webpage unresponsive
Posted: 02 Oct 2016 16:17
I have been running 2.2.3 since it came out
I fixed the issue with readkey which made the system unresponsive.
However, the system still "locks up" when run from Chrome browser.
It can take minutes for the Logion screen to appear, but will usually appear eventually
Or, I can log in, and then navigate OK for a while, and then the whole thing freezes again.
It does this in the main UI and also in Expert UI.
It seems that sending a request in the browser can take a long time for a response.
At the same time I monitor the processes running on the Pi using htop.
z-way-server is instanced multiple times, but one of these threads goes up to 100% when this unresponsiveness problem arises.
Its like the request has fully taken 100% of the processing power of one of the Pi's 4 cores, and nothing is happening until it finishes. Except it takes a really long time to finish!
I have tried upgrading to 2.2.4rc17 just to see if that helps. Same problem.
I am wondering if I have to completely start again with new install of Raspian, fresh install of z-way...
Problem is I have ~20 devices and many rules/scenes/logic to recreate.... it takes a lot of time...
Any help really appreciated.
Thanks,
I fixed the issue with readkey which made the system unresponsive.
However, the system still "locks up" when run from Chrome browser.
It can take minutes for the Logion screen to appear, but will usually appear eventually
Or, I can log in, and then navigate OK for a while, and then the whole thing freezes again.
It does this in the main UI and also in Expert UI.
It seems that sending a request in the browser can take a long time for a response.
At the same time I monitor the processes running on the Pi using htop.
z-way-server is instanced multiple times, but one of these threads goes up to 100% when this unresponsiveness problem arises.
Its like the request has fully taken 100% of the processing power of one of the Pi's 4 cores, and nothing is happening until it finishes. Except it takes a really long time to finish!
I have tried upgrading to 2.2.4rc17 just to see if that helps. Same problem.
I am wondering if I have to completely start again with new install of Raspian, fresh install of z-way...
Problem is I have ~20 devices and many rules/scenes/logic to recreate.... it takes a lot of time...
Any help really appreciated.
Thanks,