forum

Hello everybody,

I have a problem with my Zwave system. When i was trying to Get the value of my sensor with the API, the results is already 'null'. But when i get the value in the ExpertUi I have the good value.

http://192.168.43.203:8083/ZWaveAPI/Run ... null,null)

the page return 'null'.

You are a bit in a wrong board. Shall I move the thread into RaZberry board?

Please read the doc - this API sends a packet (in fact just queue it) to the target device. The resulting value is in http://192.168.43.203:8083/ZWaveAPI/Run ... 0x31].data

Ok it's working, with my command i just refresh the value in the Z-Way server.

And of course you can move this topic in an other section