Switch Status Update Problems & Other Strange Things
Posted: 02 Jan 2017 00:21
I bought the razberry controller about a month ago. It worked fine for about 3 weeks then..... The Associations in the expert UI are all red... It does not matter what I associate the device with they are all still red. Also the Status of the light switches are not updating in the UI..... I cannot figure it out and I am about to the point I am going to bag the razberry for something better...
I have tried the following...
1. Excluded and Re-included the devices (Multiple Time)
2. Formatted the Pi Multiple times and started from scratch.
3. Made Sure the Firmware was up to date.
4. Reset the API Through the advanced UI.
5. Reset the Controller
None of this has worked. If I turn a switch off in the UI it updates perfect. However if I switch the lights on manually the status does not update in the UI. All of the interviews for the switches have completed according to the UI. I am lost. I am using GE, and Zooz Branded Switches and dimmers, I am also using a schlage lock on one door, and a Zooz ZSE40 Multi sensor. Total Devices 22.
Any Help would be greatly appreciated.
I have tried the following...
1. Excluded and Re-included the devices (Multiple Time)
2. Formatted the Pi Multiple times and started from scratch.
3. Made Sure the Firmware was up to date.
4. Reset the API Through the advanced UI.
5. Reset the Controller
None of this has worked. If I turn a switch off in the UI it updates perfect. However if I switch the lights on manually the status does not update in the UI. All of the interviews for the switches have completed according to the UI. I am lost. I am using GE, and Zooz Branded Switches and dimmers, I am also using a schlage lock on one door, and a Zooz ZSE40 Multi sensor. Total Devices 22.
Any Help would be greatly appreciated.