Problem: Can't increase Danfoss thermostate temperature
Posted: 14 Jan 2017 18:41
Hi guys,
it's winter over here in Germany and I would like to modify my room temps from by my self and not by the script, I made to control my Danfoss LC13 thermostates.
I encountered 2 issues, which where not present in the past. Firmware is 2.2.5 (latest)
1) ExpertUI
No buttons to control the temperature
2) SmarthomeUI
Can't increase the temp in 0.5° steps if I click the circled button. I can change to max value and I can lower it to min and 1° steps.
Do you guys have any suggestions on this? Is it a general issue or maybe wrong setups on my side?
Cheer
Grand
it's winter over here in Germany and I would like to modify my room temps from by my self and not by the script, I made to control my Danfoss LC13 thermostates.
I encountered 2 issues, which where not present in the past. Firmware is 2.2.5 (latest)
1) ExpertUI
No buttons to control the temperature
- zway1.PNG (9.26 KiB) Viewed 3143 times
Can't increase the temp in 0.5° steps if I click the circled button. I can change to max value and I can lower it to min and 1° steps.
- zway1.PNG (9.26 KiB) Viewed 3143 times
Cheer
Grand