forum

hi you
i'm beginner with z-way me
to day i installed z-wave me on raspberry pi 3
and i try to find Fibaro Double Switch 2 but it have error
I have configured /dev/ttyAMA0 for RaZberry Daughter Card and set fequency is EU but it can't find fibaro swich
so what is my problem and how to fix it?
thanks so much to any help

Show us the log

PoltoS wrote: ↑

17 Aug 2017 00:32

Show us the log

that may log : https://drive.google.com/open?id=0BzyRU ... FZKMGtzSXc
im sory bacause I can not upload directly
and the img when i find device
thanks you for your reply

Nothing strange in the log. RaZberry just don't see anything from your Fibaro Switch.

We have seen this with Fibaro FGS/FGD modules - try to do factory reset according to their manual. And then they should include flowlessly.

PoltoS wrote: ↑

19 Aug 2017 17:44

Nothing strange in the log. RaZberry just don't see anything from your Fibaro Switch.

We have seen this with Fibaro FGS/FGD modules - try to do factory reset according to their manual. And then they should include flowlessly.

Hi Polto,
I tried again with razberry daughter card but it not suscess and i try with uzb
but when i inclusion device it have error "z-wave Expert UI error : unable to update data controller : addNote To netwwork [1]" and blue LED is not bright
when i exclusion device- LED is bright
i don't know my uzb work ?
and how to my zwave inclusion device
thanks for your help

Your donlge looks to have no license loaded in it. Check controller info page and license button

hi Polto
sorry for my stupid question but i can't find license button and controller info page
and what is license on uzb1 ?
thanks for help

The license button is under controller info page

thanks you so much
I've found license button but I have not found license on uzb1 box
so do i must buy license and I can have it where and how ?
thanks so much

It can happen that you bought the UZB1 without license. It is cheaper than the one with. You can always buy the license separatelly.