Issues with finding z-wave devices
Posted: 12 Feb 2020 01:28
Hello,
I recently bought razzberry 2.
Installed on raspberry pi 2 and was very excited!
However, after installing z-way and trying to add the new z-wave device I'm hitting a wall...
When trying to add a device - nothing happens.
I tried to read some information and I did everything I could I guess.
When my board is starting, the red and green light on board is solid for about one second.
Changed config.txt and cmdline.txt. And still nothing.
I tried to add a Fibaro motion sensor and dimmer 2. Still the same.
Could someone more experienced help me with this problem?
Regards
Zacard
I recently bought razzberry 2.
Installed on raspberry pi 2 and was very excited!
However, after installing z-way and trying to add the new z-wave device I'm hitting a wall...
When trying to add a device - nothing happens.
I tried to read some information and I did everything I could I guess.
When my board is starting, the red and green light on board is solid for about one second.
Changed config.txt and cmdline.txt. And still nothing.
I tried to add a Fibaro motion sensor and dimmer 2. Still the same.
Could someone more experienced help me with this problem?
Regards
Zacard