Hello all,
I am new to Z-Wave>me, so far I like how it works.
2 things I'm having rouble with is.
1. When I turn on any of my switches manually it doesn't update the software.
2. Temp sensors showing in metric, would like to change that to imperial.
I'm using a Raspberry Pi 4 with a Razberry hat, running firmware 5.37
What else information can I provide to help solve these issues?
Thank you for your Help
Using switch doesn't update software
Re: Using switch doesn't update software
1. Make sure to set up association in group #1 to 1:0 (if Multichannel association is possible or #1 if not).
2. Edit your config/Defaults.xml - there are two values for C/F. After that force interview for your sensors
2. Edit your config/Defaults.xml - there are two values for C/F. After that force interview for your sensors
Re: Using switch doesn't update software
I have been trying to figure out how to do this, I can't seem to get the app to work, and I haven't figured out how to edit the Defaults.xml
is there in installation guide that goes through this kind of stuff?
is there in installation guide that goes through this kind of stuff?
Re: Using switch doesn't update software
No simple guide for this.
Open in any editor /opt/z-way-server/config/Defaults.xml and change in two places <Fahrenheit>0</Fahrenheit> to <Fahrenheit>1</Fahrenheit>
Open in any editor /opt/z-way-server/config/Defaults.xml and change in two places <Fahrenheit>0</Fahrenheit> to <Fahrenheit>1</Fahrenheit>