How to upgrade the firmware?
Posted: 19 Jun 2020 11:51
Hi.
Sorry, a total newbie here...
I've installed the razberry image to a Pi 2 Model B+ and updated everything via
I went to: http://192.168.0.104:8083/expert/#/uzb
and see these entries:
and if I use the "Upgrade bootloader" button it communicates with the device (a few seconds later the green and the red led flash up for a second) but when I go to the page again I still see the same entries.
Another thing:
does not work. The tool does never show anything else than new -> lines every few seconds (the device /dev/ttyAMA0 is correct).
How do I upgrade this thing to the latest available bootloader + firmware?
Sorry, a total newbie here...
Code: Select all
Vendor: RaZberry by Z-Wave.Me
Vendors Product ID: 1024 / 1
Z-Wave Chip: ZW0500
Code: Select all
apt update & apt full-upgrade
and see these entries:
Code: Select all
2015-01-01 5.0 Update bootloader from default for 5.00 to 538d
2015-09-15 5.0 5.4 Update firmware from 5.00 to 5.04
2015-09-18 5.0 5.3 Update firmware from 5.00 to 5.03
Another thing:
Code: Select all
./ZMESerialUpdater serialapi_uzbupdate -d /dev/ttyAMA0
How do I upgrade this thing to the latest available bootloader + firmware?