[SOLVED] Z-Wave.me Expert UI not accessible
Posted: 02 Nov 2020 20:00
Hi folks,
I use Z-Wave ZMEERAZ2 Z-Wave.Me RaZberry 2 Modul on my pi (Pi 3 Model B+, runnign on buster) together with domoticz (Version: 2020.2, dzVents Version: 3.0.2) and up until two days ago everything was fine.
The suddenly one device (EUROtronic EUR_SPIRITZ Wall Radiator Thermostat+) was excluded from system. I tried to include it again, but no success. I thought, it is the device, so I got the new one, but i couldn't include it via domoticz neither. Everything else is working OK, devices are there, scripts work, too. I never used z-wave ui to inculde devices but I read I shall try this. Well, I wanted, but I couldn't call the WebUI.
First I found out it is because the most of the time the z-wave-server is dead so I cannot call the WebUI at all.
When I restart the service I can log in but then I get a communication or binding error
Can anyone tell me how can I get the Expert Ui working so I can try to include the device via this UI to see if it works.
thx,
zavjah
I use Z-Wave ZMEERAZ2 Z-Wave.Me RaZberry 2 Modul on my pi (Pi 3 Model B+, runnign on buster) together with domoticz (Version: 2020.2, dzVents Version: 3.0.2) and up until two days ago everything was fine.
The suddenly one device (EUROtronic EUR_SPIRITZ Wall Radiator Thermostat+) was excluded from system. I tried to include it again, but no success. I thought, it is the device, so I got the new one, but i couldn't include it via domoticz neither. Everything else is working OK, devices are there, scripts work, too. I never used z-wave ui to inculde devices but I read I shall try this. Well, I wanted, but I couldn't call the WebUI.
First I found out it is because the most of the time the z-wave-server is dead so I cannot call the WebUI at all.
When I restart the service I can log in but then I get a communication or binding error
Can anyone tell me how can I get the Expert Ui working so I can try to include the device via this UI to see if it works.
thx,
zavjah