smoke sensor not shown in Expert UI

[0ese]

My smoke detector ZS6101EU (Vision Security) is included in my controller (RaZberry). If I go to "Configuration" and select the device I can see the command class including "Alarm". Clicking on that I can read "Smoke".
If I go to "Control", "Sensors" I can only see a "General Purpose" sensor. I guess, this is the Burglar/Tamper sensor. But the "Smoke" sensor is not shown.
Any hints where to look at?
Thanks, 0ese

[PoltoS]

Is it rendered in Smart Home UI?

[AlphaX2]

Hi,

I've an equivalant case: Fibaro FGSS-002 shows just the "AlarmSensor" command class items in ExpertView, "Alarm" command classes are not shown, but both rendered in standard SmartHome interface.