Hi!
I've got a Window/Door Sensor from Fibaro, and the tamper alarm is constantly in an "ON" state. The alarm is activatet by pushing the button on the back of the sensor.
This isn't a problem when using for example a Fibaro Motion Sensor, because that sensor resets the tamper alarm after a set time.
How can I reset the tamper alarm in the Door/Window sensor without having to remove it from the system and adding it again every time? Is there any script commands I can use?
Thanks!
- Vegard
Fibaro Door/Window Sensor - Reset tamper
Re: Fibaro Door/Window Sensor - Reset tamper
Hello Vegard, I am facing the same problem.
Did you find a solution?
Thanks
Erik
Did you find a solution?
Thanks
Erik
Re: Fibaro Door/Window Sensor - Reset tamper
Some devices do not reset back the tamper after they are back to normal position.
For such devices, we have a "postfix" with emulateOff. Please check the following example:
https://github.com/Z-Wave-Me/home-autom ... json#L5705
Postfix can be added in Expert Mode (enable Debug mode in Controller Info tab) or push your postfix to this file (we accept Pull Requests!)
For such devices, we have a "postfix" with emulateOff. Please check the following example:
https://github.com/Z-Wave-Me/home-autom ... json#L5705
Postfix can be added in Expert Mode (enable Debug mode in Controller Info tab) or push your postfix to this file (we accept Pull Requests!)