CT30 Thermostat problem
Posted: 11 Feb 2013 05:24
I am having problems with getting a CT30 thermostat to work as I want. I feel I should disclose the distinct possibility that I do not fully understand the Climate control in Zway.
When I set the Thermostat to Manual in Zway and control the Set Temp using just the interface on the thermostat itself, all works as expected. If I set Zway to control the thermostat the temp shown in "Device Control">Thermostats does not match what I put in the Climate Schedule. Further, it is showing the Temperature in Fahrenheit, even though the CT30 is showing Celsius and the Climate Schedule is set in Celsius. I put 20 degrees C in the Climate Schedule, but the Thermostat info says "67 grd F" for the Maintained Temp and "(20+47)" for the calculated temp. When in Automatic mode, if I try to adjust the temp up or down the display momentarily shows the correct information in red 25 and (20+5), but then quickly goes back to 67 and stays there. The Target Temp on the thermostat goes to 01.5 degrees when I try to make adjustments from Zway.
When watching the log file, I do not see anything odd. It reports that the temp changes have been set. Am I doing something wrong?
When I set the Thermostat to Manual in Zway and control the Set Temp using just the interface on the thermostat itself, all works as expected. If I set Zway to control the thermostat the temp shown in "Device Control">Thermostats does not match what I put in the Climate Schedule. Further, it is showing the Temperature in Fahrenheit, even though the CT30 is showing Celsius and the Climate Schedule is set in Celsius. I put 20 degrees C in the Climate Schedule, but the Thermostat info says "67 grd F" for the Maintained Temp and "(20+47)" for the calculated temp. When in Automatic mode, if I try to adjust the temp up or down the display momentarily shows the correct information in red 25 and (20+5), but then quickly goes back to 67 and stays there. The Target Temp on the thermostat goes to 01.5 degrees when I try to make adjustments from Zway.
When watching the log file, I do not see anything odd. It reports that the temp changes have been set. Am I doing something wrong?