forum

Hello,

I can't seem to get the lock to include in Z way. I ask the software to include a new device and then I press the connect button on the lock but the light doesn't turn yellow (according to the lock instructions that is supposed to happen)

Am I doing something wrong or is the lock bad?

Here is the log...

2013-06-17 17:29:01.203] Job 0x4b: deleted from queue
[2013-06-17 17:29:01.240] Job 0x4b: deleted from queue
[2013-06-17 17:29:01.253] Job 0x4a (Add/re-include node to network): Job not removed before timeout (awaiting for more callbacks?)
[2013-06-17 17:29:01.256] Job 0x4a (Add/re-include node to network): Cancelling
[2013-06-17 17:29:01.258] Job 0x4a (Add/re-include node to network): fail
[2013-06-17 17:29:01.260] Adding job: Add/re-include node to network
[2013-06-17 17:29:01.273] SENDING (cb 0xc5): ( 01 04 00 4A C5 74 )
[2013-06-17 17:29:01.290] RECEIVED ACK
[2013-06-17 17:29:01.292] Removing job: Add/re-include node to network
[2013-06-17 17:29:01.337] RECEIVED: ( 01 07 00 4A 1A 06 00 00 AE )
[2013-06-17 17:29:01.344] SENT ACK
[2013-06-17 17:29:01.345] Job 0x4a (Add/re-include node to network): Done
[2013-06-17 17:29:01.347] SETDATA controller.data.controllerState = 0 (0x00000000)
[2013-06-17 17:29:01.348] Removing job: Add/re-include node to network

Hobs

I got it to work...



Hobs

Please tell us how you did it so others can learn from your experience