forum

I have a RaZberry with Z-Cloud installed. I'm trying to set up some automation tasks and scenes.

I've configured scenes "Porch light on" and "Porch light off". The porch light is connected to one of the outputs of the Fibaro FGS221. The scenes work fine when manually activated.

In the porch I've got an Aeon 4 in 1 multi-sensor. I want to configure a rule (or rules) which will turn on the porch light if motion is detected, as long as the current light level is below a certain value (I will experiment to find a suitable number). Then, if no further motion has been detected within 5 minutes, the light should turn off again.

I am unable to even get past the first step, I can't get the light to turn on at all, even ignoring the light sensor.

Help!

On a related note, is there any way I can view the stream of events emitted by a given device?

Thanks

Jon

I can't even create a simple rule triggered by the motion detector. It never triggers. According to the Aeon multisensor manual, it is supposed to send a Basic set (0xFF) to associated devices when triggered. It's associated with Device 1, my RPi with RaZberry & Z-Way. I can't get the rule to work though.

Yes, I have the same issue with Aeon multisensor. I can see from the log that it is actually triggered but razberry does not update the status. Looking forward to a solution.