forum

I have a lot of 'Fibaro D/W Sensors', the ones that have a temperature sensor attached are not handled correctly on Z-Cloud. The State text is not updated when triggered ('Idle' is shown even if it is triggered), I see the following "fibaro" lines when I select menu option 'Device control --> Sensors'.GREEN_ICON       FibaroSensor(#1)      Not placed in zone        State          Idleinstead of GREEN_ICON       FibaroSensor(#1)      Not placed in zone        State          Triggered The consequence on iOS Z-Way Application is that the sensor state is not updated ...

This is a problem with Fibaro sensor that it reports SensorBinary twice: outsideo of channel and inside channel 1. The report comes only on the one without the channel, but Z-Way always assume that if there are channels, everything should be in it. We will negociate with Fibaro about this to get a solution.