forum

Dear all,

I tried to associate the fibaro FGBS321Universal Binary Sensor to z-wave me but the device is not recognized.

Do you maybe had the same issue ? are there any plan to add the module which is very interesting.

Thank you for your help

With software 1.4 I have included the device. The inputs seem to trigger. I have one temperature sensor connected, but it does not show-up under device configuration nor under the expert commands. A "forced reinterview" does not make it visible either. I would have expected a sensorMultilevel
Is this a known issue with Fibaro Universal Sensor?

For some reason this problem disappeared after a couple of re-interviews. (As required I did have the temperature sensors attached before including the device to RaZberry)