forum

hello

I installed the smoke detector FSS 001,the temperature is displayed but nothing against the smoke . How to have the state feedback ?

thank you

This device uses Alarm CC. We are working to make it work in latest versions.

thank you poltoS, hoping you'll get there soon

Any news from this?

Neither smoke alarm nor temper alarm outputs anything in any way.

The FSS-001 also have a "black box recording" which I'm not sure what it is and how it's supposed to work, starting to log smoke levels before the alarm is triggered.

Actually I get alarm readings fine, although I have only tested the tamper alarm "General Purpose Alarm". Heat and Smoke alarms show up as well.

I'm not sure if I see any smoke readings. Will do a smoke test at some point later.

Just added AlarmSensor in v2.0.1-rc2

I saw, great. (I'm actually mainly using the JSON interface, and that worked since v2.0.0. I also wrote a backend to SMS me on these events.)

I still don't know how the "smoke level" logging is supposed to work, but I'll try with some smoky burning newspaper some other day.


edit: Where can I see "AlarmSensor" in the interface? I can't find it anywhere in rc7 (which I presume will have that as well), neither /expert nor /blueui. It might be in the home automation, but I haven't learned how to navigate that.

- Sensors (Generale purpose alarm / Smoke / Heat) ghost appearing with the expert interface. Against only by the temperature with blueui

- Too bad there is still no sensor (idle / triggered) that informs the detector status

Z way version 2.0.1-RC12

The same problem as the KFOB Zwave me always no return of state JSON.

I hope that the update will soon arrive, her this kept waiting!

At present unusable with openremote!!