forum

Hi,

I received my RC2 (remote Controller) yesterday and trying to get it work with my Z-Way (2.0.1-rc25).
Device inclusion worked fine. Configured button parameter to "4" (send Scenes).
My question is, how to handle the commands in Z-way to activate scenes which are defined in home automation UI.

Any hints?

Thank You
Quax1507

In HA UI you can enable Remote Switch Generator and then bind "autocreated" scenes with actual scenes.

Or you can use JS code to do it (more for programmers)

Could You please explain it a bit more?
I opened "Remote Switch Generator" but cannot see any scenes in it.

JS could be an alternative. Do You have any examples for that?

OK, I found out how to do this using HA UI.
I am able to bind switches but not scenes.
Any hints for that?