forum

Hi,
I've aquired a Schwaiger ZHS 01 which was successfully included in my network. After Interview the device works out of box but I cannot configure it as I need to define a profile for it. I have absolutely no idea what Device should be selected in the drop down.

I'm using the razberry module on a rasbperry pi B+ using the zway SD-Card Image.

OK, seems as this device is a rebrand of the qubino flush dimmer. As seen on device specific post for qubino there seem to be some problems.
Also I noticed that this device has more configuration parameters as there are available in the config interface. Is there a way to extend the config for the missing parameters or do I have to set them via expert command?