forum

Hello again,

I noticed another thread for the ZME_RC2 configuration but as the owner didn't report back yet, I didn't want to hijack his thread.

I included my ZME_RC2 Remote and trap event binary buttons are correctly displayed (after first use of them on the remote) and the current status is visualized. With direct association in Z-way I am able to move my window shutters up and down, but only into their respective final positions. Same with if-then-else.

Pressing and holding the remote button for "Dimming" as in the instruction manual does not do a thing. Am I missing something here?

Greetings,
rws

[edit] my apologies, should be in device specific section
[moderator] Moved

Hi there,

association solved the problem, done via expert gui. Took some sweet time to store the config, but it works

Hooray!

rws