Page 1 of 1

Fibaro FGMS-001 v3.2

Posted: 06 Jul 2016 15:43
by homespear
So I got a Fibaro Multi Sensor and added it to Z-Way (Razbian). Temperature and Luminescence values show up fine, but I can't figure out how to get the motion sensor working. The regular UI just shows a "Fibar Group General Purpose alarm Alarm" device which is apparently set to "On". The Expert UI indicates a General purpose device and a General Purpose alarm device. Both which state "Triggered".


Re: Fibaro FGMS-001 v3.2

Posted: 04 Aug 2016 20:46
by PoltoS
What do you see in the log when it detect motion or after long idle?