Lock interviews perfectly when the controller (Raspberry Pi2) is within inches of the lock. I wait (perhaps not long enough) and verify that the interview is indeed complete. After I move my controller back to it's permanent location (10-15 feet away) the lock via the expert UI indicates the device seems to be dead. The closet where it's installed has a Fibaro Multi-sensor, a Fortrezz Mimolite (mains) and a few feet away there is a Aeotec Siren (mains) and Leviton Switch (mains). All working perfectly in the same/greater distance. I cannot control this lock at all using the UI (/smarthome). When operating the lock locally, nothing is updated on the UI. I've added to the log (attached) the timeframe when I unlocked the lock locally. As you can see, it appears the lock is conversing with the controller.
Edit: Or is this perhaps the resolution I'm seeking (I just don't know) ?
Any assistance is greatly appreciated...
Code: Select all
Interview-Status Interview complete + +++ +++++++++++++ Wireless Activity Device seems to be dead Application version 21.32 SDK version 4.53.00 Command Class Basic, DoorLockLogging, ScheduleEntryLock, DoorLock, UserCode, Configuration, Alarm, ManufacturerSpecific, Protection, Battery, Association, Version, Time, TimeParameters, Security, Security interview (check mark)
App Version: 2.6
Vendor: RaZberry by Z-Wave.Me
Z-Wave Chip: ZW0500
Serial API Version: 05.00
Version number: v2.2.2
Compile-Date: 2016-04-11 11:00:34 +0300