Page 1 of 1

Qubino Flush Shutter reverse command

Posted: 24 Jul 2017 00:03
by stich86
Hi guys

I've installed a Qubino flush shutter on a roller but I've two big issues:

Local buttons works as expected, but on the GUI if I press UP button my roller goes down while if I presso DOWN it goes up. Also percentage are inverted (0% open, 99% close)

Can someone help me? I've just included the device (few times before installation - on this ice another question.. is it possible to reuse Nose ID? Now I'm at n.5 ..) and nothing more.
I've also created my own xml files (using the one from OpenZwave)

Thanks for any help!