Page 1 of 1

Is GE/JASCO 26931 Motion Sensor Switch supported?

Posted: 04 Jan 2018 11:56
by johnpdowling
My GE/Jasco 26931 never completes interviewing with z-way. Whether I exclude/include, factory reset, nothing lets z-way complete the interview process, manually/forced or not. The device shows up with 2 each of the switch and motion sensor. One switch always shows on, the other does show the correct device status and allows control of the device. Neither of the motion sensors update in the UI even though the device is correctly operating itself according to motion.

fw2.3.6, updated XMLs

Any help or further necessary information?