qubino thermostat 2 (ZMNKID1) cant set offset

Discussions about existing Z-Wave device and their usage with Z-Way/Z-Cloud/Z-Box
Post Reply
seiken
Posts: 20
Joined: 23 Jan 2021 00:54

qubino thermostat 2 (ZMNKID1) cant set offset

Post by seiken »

Hi
when adding my Qubino thermostat 2, ZMNKID1 i cant change the value for parameter 110,
it only show checkboxes. and doing it in expert will result in error, exempel i need to lower the temp with -44 (-4.4C)
the device starts clicking and showing 65492 and no change is made to the displayed temperature.
if i change it to 44 (without -) then i changes to this but it doesnt change the display temp.
i have the same behavior on 7 devices (tested on a total of 8 devices all doing the same thing)
Skärmbild (24).png
Skärmbild (24).png (608.47 KiB) Viewed 4934 times
Skärmbild (25).png
Skärmbild (25).png (368.05 KiB) Viewed 4934 times
//Regards
piet66
Posts: 266
Joined: 04 Feb 2017 17:00

Re: qubino thermostat 2 (ZMNKID1) cant set offset

Post by piet66 »

I doubt that the expert mode accepts negative numbers. You will have to convert your input.

I don't know ZMNKID1, in other Qubino devices 0°C = 32536. I suspect that the description is wrong.
Raspberry Pi 3 Model B Rev 1.2
Raspbian GNU/Linux 10 (buster, 32bit)
RaZberry by Z-Wave.Me ZW0700 7.20.00 07.38/1766938484 1025/257
Z-Way version v3.2.3 from 2022-04-06 04:56:23 +0300
seiken
Posts: 20
Joined: 23 Jan 2021 00:54

Re: qubino thermostat 2 (ZMNKID1) cant set offset

Post by seiken »

piet66 wrote:
25 Feb 2021 23:24
I doubt that the expert mode accepts negative numbers. You will have to convert your input.

I don't know ZMNKID1, in other Qubino devices 0°C = 32536. I suspect that the description is wrong.
hi

il talk to qubino and they claim it should be -44 thay are sending new thermostat 2 modul to me with a modified firmware to try, if it works they will update my other qubino thermostat 2.

questone, basically every device i ad, it chooses the wrong type, instead of EU version i pick some other version, then when i manually set it to the correct devices it displays error in settings, the device is in default state.
Is this normal?
Skärmbild (26).png
Skärmbild (26).png (515.47 KiB) Viewed 4904 times
Skärmbild (45).png
Skärmbild (45).png (534.39 KiB) Viewed 4904 times
Post Reply