Page 1 of 1

[userModule] Binary Sensor Filter

Posted: 26 May 2018 00:57
by fez
This module creates a virtual binary sensor. The value of the virtual sensor is based in the input device and its recent history. For example: if the polling interval is set to 5 minutes and filter level to 2 and level off the virtual sensor will keep the the on status as long as the input device is off for less then 2 intervals. A possible use case if a presence indicator while still keeping to motion sensor relative accurate (short on time The on & off option creates a hysteresis. In this mode the filter level alternates automatically once a stable level is reached according to the filter parameters.

Token: fermit_beta

Re: [userModule] Binary Sensor Filter

Posted: 24 Apr 2019 15:47
by fez
Sorry, but I don't understand how is your topic related to the "Binary Sensor Filter" user module.

Re: [userModule] Binary Sensor Filter

Posted: 25 Apr 2019 15:34
by Eagle
benniefum is just a bot, his massage is copied from another thread/forum