FW 3.10 & zwave saturation

Discussion about Z-Uno product. Visit http://z-uno.z-wave.me for more details.
Post Reply
Posts: 33
Joined: 17 Sep 2021 18:05

FW 3.10 & zwave saturation

Post by yves »

Hi all,

Following my previous post https://forum.z-wave.me/viewtopic.php?f=3427&t=35912
I confirm that the answer from p0lyg0n1 is probably right. Under firmware 3.10 there is a problem with Zwave communication ‘saturation’… Especially painful when module is far away (but not only?)
In my case, the trouble is that Z uno2 boards modules reboot erratically, I would say 2 to 3 times per week.

For now, I don’t want to go for next FW version until it is not declared ‘stable’ and we can’t get back to previous one.

So, I just want to share some workarounds that seem ‘efficient’ so far.
Here they are:
1) Do no overload (event punctually) Zwave comms with zunoSendReport calls.
In my case, finally, I scan all my devices every 200ms,
In the ‘for loops’ scans, I use a break as soon as one requires a zunoSendReport.
So at most 5 reports are sent (requested) per sec.

Then, in this 200ms loop, you must prioritize your zunoSendReport:

2) First scan your input devices, if one requires zunoSendReport break and do not scan/report ‘output’ devices.
(I think that giving highest priority to input channels solves to some acknoledge issues ?, is it HC3 specific?)
(Rem:to me, input means input to the zwave module)

3) Then scan output devices.

4) Ends eventually with devices that are “REQUESTING”, you are not in hurry for those one :) !!

5) If you use eeprom writes, try to avoid doing it during Zwave exchanges. Easy to say!!!

6) Same remark for configuration parameters modifications...

I think that some of my troubles come from my Home Center 3 untold requirements/Zwave protocol interpretation, but it make a so great difference that it must be a shared issue!!

Have a nice day!
Best Regards,
Post Reply