forum

Hey,

has anyone some knowledge about how much current is needed to run the z-uno without attached hardware (average consumption and max consumption when the device is in 'standby', receiving or sending data from/to zwave controller)?
Just asking myself whether we can use some energy harvesting concepts to design an autarc zwave device. =)

Thx in advance!
Dataworm

Hi,

nearly values:

sleeping - about 2uA
FLiRS - about 50uA (it is a average value between sleeping time and wake-up)
active/sending - about 45mA

Best regards
Michael

Thx a lot,

this was quite helpful. As expected it seems to consume much less current than such an esp module! =)

Best regards
Dataworm