Digital Output Pins 19-22

[joergm6]

Hello
I use 4 switches on pins 9-12 (digital-out). Everything works wonderful.
If I only change pins 9-12 to 19-22, everything else remains unchanged, then the outputs switch only shortly for a fraction of a second (LED flashes shortly).
Currently I need only 4 pins, but wanted to ask.
thank you

[A.Harrenberg]

Hi,

I found that the pins 19 to 22 are going to LOW state when a ZWave transmission is active, so zunoSendReport() from the sensor or a command from the controller to the Z-Uno.

I expect that this is what you experience here as well.

It was reported and the team is currently looking for the root cause of this. So for now I would recommend to not use the pins 19 to 22 at all.

Regards,
Andreas.

[joergm6]

Thanks for the information. I had started with these pins to try and after a few hours ... I doubted myself . But 9-12 is working and that is enough for me at the moment.
regards

[RobertHerter]

Any News here ?.

for my Controller i need 8 Digital Outs. 19-22 are unusable, because of switching on z-wave transmit.

Regards

Robert

[michap]

for my Controller i need 8 Digital Outs.

you can use Pin 9-16

Michael

[PoltoS]

You can also use pins 0-8. We will focus on this in next release after NY.

[Rogga10000]

Bad news for me. Planning control a relay from Pin 17 to make it work on the circuit board layout.

I did not manage to read analog values ​​from input A2 and A3 to my Fibaro. My code is based on the 10 channel example.

I will patiently wait for the next version and hope you manage to bring order to these basic bugs

[PoltoS]

Problem found. We will fix it in 2.0.8

[PoltoS]

viewtopic.php?f=3427&t=24573