I don't know if I explained myself well, what I meant is that the ZUNO, at this moment, can only be seen and used in Fritzing's "breadboard" mode. My proposal is that it can also be viewed in "schematic" and "pcb" modes.
In my opinion, this would facilitate the work of the ZUNO community, to make more solid developments with ZUNO, especially with regard to designing the printed circuit boards.
Fritzing
Re: Fritzing
Sure, I understood you right. When we did Fritzing, we expected many people to use it, but actually thare are not that many.
We did it more to draw beautiful examples on our site But anybody can extend our Fritzing file to add the schematic and pcb sections too.
We did it more to draw beautiful examples on our site But anybody can extend our Fritzing file to add the schematic and pcb sections too.
Re: Fritzing
My "semi-solution" is to use the generic pin headers in Fritzing. it does not help at all in the Schematic view, but it helps in the PCB view where you can easily place 2x15 pins on the board to look like the z-uno.