Fritzing

Discussion about Z-Uno product. Visit http://z-uno.z-wave.me for more details.
jalvarezprz
Posts: 9
Joined: 21 Jul 2020 23:47

Re: Fritzing

Post by jalvarezprz »

I don't know if I explained myself well, what I meant is that the ZUNO, at this moment, can only be seen and used in Fritzing's "breadboard" mode. My proposal is that it can also be viewed in "schematic" and "pcb" modes.
In my opinion, this would facilitate the work of the ZUNO community, to make more solid developments with ZUNO, especially with regard to designing the printed circuit boards.
User avatar
PoltoS
Posts: 7565
Joined: 26 Jan 2011 19:36

Re: Fritzing

Post by PoltoS »

Sure, I understood you right. When we did Fritzing, we expected many people to use it, but actually thare are not that many.

We did it more to draw beautiful examples on our site ;) But anybody can extend our Fritzing file to add the schematic and pcb sections too.
perjar
Posts: 57
Joined: 08 Apr 2018 18:02

Re: Fritzing

Post by perjar »

My "semi-solution" is to use the generic pin headers in Fritzing. it does not help at all in the Schematic view, but it helps in the PCB view where you can easily place 2x15 pins on the board to look like the z-uno.
Post Reply