Ok.. Getting goofy...

[janjoh]

Soeee.. Three powermosfet channels. (Two intended for PWM-fans to be able to turn them off completely)
Two separate 1 wire buses.
Plain breakout for Pin 1-15
Polyfuse
Optos for the PowerMosfets



Let's see what damage i can do with this

CAD'ed in KiCad. PCB's courtsey of AllPcb.com

[PoltoS]

Looks nice! Would be know what you have finally done with this. Please share your experience!

[janjoh]

Ok, since "real work" has kept getting in the way of hobbies, it's taken a bit longer then expected .. but now, lets start testing

Since the Z-Uno uses a nonstandard 30pin/0.7" width i simply took a standard 32pin/0.6" socket and cut it down the middle and cut of the last pair of legs to make it Z-uno friendly

E36E1A23-16A4-4DFA-9DD4-C7BEF0B4AA28.JPG (37.55 KiB) Viewed 5942 times

9B132709-9433-4B13-899B-195901647047.JPG (34.32 KiB) Viewed 5942 times

[PoltoS]

Few photos of final device and a detailed description of installation and we can place it on our project page. If you permit

[janjoh]

Few photos of final device and a detailed description of installation and we can place it on our project page. If you permit

No problem.. If it will work

Right now I just keep findina a compiler error, even with simple sketches...

https://forum.z-wave.me/viewtopic.php?f=3427&t=24687