forum

Soeee.. Three powermosfet channels. (Two intended for PWM-fans to be able to turn them off completely)
Two separate 1 wire buses.
Plain breakout for Pin 1-15
Polyfuse
Optos for the PowerMosfets



Let's see what damage i can do with this

CAD'ed in KiCad. PCB's courtsey of AllPcb.com

Looks nice! Would be know what you have finally done with this. Please share your experience!

Ok, since "real work" has kept getting in the way of hobbies, it's taken a bit longer then expected .. but now, lets start testing

Since the Z-Uno uses a nonstandard 30pin/0.7" width i simply took a standard 32pin/0.6" socket and cut it down the middle and cut of the last pair of legs to make it Z-uno friendly

Few photos of final device and a detailed description of installation and we can place it on our project page. If you permit

PoltoS wrote:Few photos of final device and a detailed description of installation and we can place it on our project page. If you permit

No problem.. If it will work

Right now I just keep findina a compiler error, even with simple sketches...

https://forum.z-wave.me/viewtopic.php?f=3427&t=24687