Hi
During the weekend I sat down with my new Z-uno and tried examples from https://z-uno.z-wave.me/ to my Z-uno and my Telldus Znet v2.
I tried a simple switch without any problem, and also expand it to be 2 switches, still no problem.
Later I tried a simple temp. sensor, and it worked perfectly.
The I tried the final goal, to handle 5 different temp. sensors. Now I got the problems.
I can se the different units in the Znet, but they show no temperature. They just appear in the Znet, but do not show any temperature or anything else.
Is there some adjustments to be set in the Telldus Znet, or is it some problem with the compatibility between Z-uno and Znet?
Hope someone can give me some input.
I tried the examples from https://z-uno.z-wave.me/examples/ and also tried to modify them, but nothing sems to work.
Best regards
xph
Z-Uno on a Telldus Znet v2 with 8 sensors
Re: Z-Uno on a Telldus Znet v2 with 8 sensors
Did you try "10 channels" example? If you have problems with it too then you have to seek for the problem inside your controller. This sketch was certified and works right.