forum

Hello,

Is it possible to send text over Z-wave from Fibaro HC2 or Domoticz (on Rpi) to Z-uno?

I like to connect a display to the Z-uno and display messages from my Z-wave controller.

And after that i like to confirm or dismiss these messages with 2 buttons and send the status back to a HC2 scene

Thanks!

There is Display Comamnd Class in Z-Wavefor such tasks, but no controller do support it (as I know). So, either use pre-defined messages and choose scenes/dimming levels to select them or use Configuration Command Class to send by 4 characters. But the latter is really tricky...

pre-defined is possible for arming/disarming, showing device on/off but not for displaying the contact names on phone-calls (i have my voip fritzbox router connected to my controllers)

Unfortunatelly, even if Z-Uno supports this (pretty easy to implement), controller do not support this.