forum

i just got this z-uno yesterday.. i followed the quick start guide and had a sketch running in no time..

today i sat down to work on it again and cannot for the life of me get a sketch to upload. I have tried on multiple PCs and multiple USB cables.

Ive tried the reset instructions and even the device reset without any progress.. see screenshots for some more info..

if there are logs or something that would be helpful please let me know where they live and i will share.. thanks for the help!

Ah..nevermind..i wasnt doing the rescue mode properly.. i got it working..

wasnt sure if i should just delete this post or reply to myself.... maybe someone else is seeing the same error messages and will see what worked for me?