No channels registered when selecting S2 security
Posted: 02 Jan 2019 22:54
I just bought a Razberry and Z-uno to automate my doorlock. I have an issue that when I set Z-uno in S2 security mode the controller (Razberry) registers the device but without any channels. I did the test with the SimpleBinarySensor exemple without anything connected to Z-uno:
- in No Security mode it works fine, Z-way registers the device with 2 channels that are updeated when I press the button.
- in S2 mode Z-way registers the device without any channels. The sketch seems to work on Z-Uno as the LED reacts to the button. I followed the instruction to update the Z-uno bootloader as described on the web page.
What can be the cause of this behaviour?
- in No Security mode it works fine, Z-way registers the device with 2 channels that are updeated when I press the button.
- in S2 mode Z-way registers the device without any channels. The sketch seems to work on Z-Uno as the LED reacts to the button. I followed the instruction to update the Z-uno bootloader as described on the web page.
What can be the cause of this behaviour?