forum

Hello,

I have the problem that my Z-Uno is consuming to much current in sleep mode.
The specific sleep mode is "FLiRS" with a timer:

"
ZUNO_SETUP_SLEEPING_MODE(ZUNO_SLEEPING_MODE_FREQUENTLY_AWAKE);
.............
.............
zunoSetBeamCountWU(30);
zunoSendDeviceToSleep();
"
When measuring the current with an oscilloscope I get between 20 and 40 mA when awake and around 6 mA when sleeping with a 9 V source connected to the 7 - 18 V input pin.
According to the "Z-Uno-Quick-Start-Guide" the current consumption in sleeping mode is suppost to be "around 25 µA".
Are more commands needed to get to that level besides the "zunoSendDeviceToSleep()" command?

Regards
Oliver

https://z-uno.z-wave.me/technical/

When powering from 7-18 the consumption will be always big.