Wakeup not working

Discussion about Z-Uno product. Visit http://z-uno.z-wave.me for more details.
Post Reply
kina500
Posts: 15
Joined: 21 Jan 2021 20:49

Wakeup not working

Post by kina500 »

Hi

I am trying to get a sketch to work like this one:

https://z-uno.z-wave.me/projects/sensor ... olo-glass/

When the Z-Uno module goes to sleep, it do not wakeup on Int1 through the diodes.

Do I have to setup or enable the interrupt?
The sketches all over Z-Uno page with sleep and wakeup examples, do not show I have to setup interrupt separately, but that INT1 should always wake a sleeping Z-Uno.
kina500
Posts: 15
Joined: 21 Jan 2021 20:49

Re: Wakeup not working

Post by kina500 »

I used the blinds channel in above sketch.
Can you not put a battery operated blind into sleep mode?
kina500
Posts: 15
Joined: 21 Jan 2021 20:49

Re: Wakeup not working

Post by kina500 »

No, you cannot use the the blind zwave setup, if you want to sleep your device!
User avatar
PoltoS
Posts: 7565
Joined: 26 Jan 2011 19:36

Re: Wakeup not working

Post by PoltoS »

why not?
kina500
Posts: 15
Joined: 21 Jan 2021 20:49

Re: Wakeup not working

Post by kina500 »

Don't know.
If I chose Zuno blinds in Zwave setup, it is not possible to run sleep mode and wakeup.

Found this in the referencer ZUNO_BLINDS:
This type is allowed only in ZUNO_SLEEPING_MODE_ALWAYS_AWAKE power mode (see ZUNO_SETUP_SLEEPING_MODE).
Post Reply