forum

I apologize if this topic has been convered ad-naseum, but I really did search and search and search without much luck.

I see the configuration values as listed here: https://z-uno.z-wave.me/z-wave/configur ... arameters/

What I can't for the life of me figure out is: How do I actually set those parameters? I want to change parameter 11 (seconds between Sensor Multilevel reports), but I can't seem to find the relevant configuration options. I am using OpenZWave via Home Assistant, if that helps. I see no comparable config values in the OpenZWave web UI.

I feel like there some sort of config file located somewhere on my hard drive that I need to change, but after hours on this, I'm totally stumped. Help?

OpenZWave should have some UI to set Config parameters. Not sure how it works in HAss and in OZW, It should be a UI to send configuration commands to Z-Uno