Hanging Z-UNO - Update firmware ?
Posted: 26 Jul 2021 22:11
I have two z-uno´s working with the same controller.
The oldest bougth and in operation since 2019, Z-UNO01, has according to the Z-wave expert UI - in teh Firmware Update a Application Version 2.15.
The newest bougth and in operation this year (2021), Z-UNO02, has has according to the Z-wave expert UI - in teh Firmware Update a Application Version 2.17.
In the house where these two Z-UNO are located there is from time to time electricity outage. Z-UNO02 starts up fine when the electricity comes back but Z-UNO01 looses the connection to the controller or are "hanging". I hhold the BTN button and push the RST button, and the Z-UNO01 are alive again.
The sketch on the Z-UNO01 are a bit more complicated than the one on the Z-UNO02. Both are enclosed as zipped WORD files. Z-UNO02 are produced by myself with teh Z-UNO configurator with some adjustments, while the Z-UNO01 sketch are produced of some more proffesional actors.
Question is why the sketch or Z-UNO on the Z-UNO01 hangs after electrificty outage? Would it be an idea to upgrade the firmware ? Nad how do I proceed with that. I have done this previously with other Z-Wave units from teh expert UI, but are not very familiar with the process. And if I go for that where do I find the firmware file ?
The oldest bougth and in operation since 2019, Z-UNO01, has according to the Z-wave expert UI - in teh Firmware Update a Application Version 2.15.
The newest bougth and in operation this year (2021), Z-UNO02, has has according to the Z-wave expert UI - in teh Firmware Update a Application Version 2.17.
In the house where these two Z-UNO are located there is from time to time electricity outage. Z-UNO02 starts up fine when the electricity comes back but Z-UNO01 looses the connection to the controller or are "hanging". I hhold the BTN button and push the RST button, and the Z-UNO01 are alive again.
The sketch on the Z-UNO01 are a bit more complicated than the one on the Z-UNO02. Both are enclosed as zipped WORD files. Z-UNO02 are produced by myself with teh Z-UNO configurator with some adjustments, while the Z-UNO01 sketch are produced of some more proffesional actors.
Question is why the sketch or Z-UNO on the Z-UNO01 hangs after electrificty outage? Would it be an idea to upgrade the firmware ? Nad how do I proceed with that. I have done this previously with other Z-Wave units from teh expert UI, but are not very familiar with the process. And if I go for that where do I find the firmware file ?