Post by davidtheITGuy » 15 Jun 2023 16:34
Yes I’ve looked into parameters but it’s not clear how to dynamically set them from a GUI (server) driven message.
Frankly, that’s the problem I think with the Zuno is that it implements several device classes (eg binary switch, dimmer, etc) but the device classes are slave to the ZWave specification which limits values that can be set/get.
Maybe that's it? Is it limited in values, depending on what kind of device?
Hello everyone, I precisely have that limitation too. I only want to send values of 1 degree to 220 or -5 to 220 degrees, just that, through a multilevel temperature sensor channel, we have 4 bytes to store that, if I'm not mistaken. But it has been impossible for me, it only sends up to 125 degrees. I have a thread here also talking about that. Does anyone know why this happens?
Greetings.
https://forum.z-wave.me/viewtopic.php?f ... 49243274bb
Question on a Supporting a Virtual Device
Re: Question on a Supporting a Virtual Device
It looks like a Fibaro issue in your case