Error setting "thermostat setpoint" value between -12.8 and + 12.8°C
Posted: 12 Jul 2023 17:07
I use HA 2023.7.1 with Z-Wave JS UI 1.14.0
Firmware ZUNO 3.0.10 (but tried with 3.0.12 beta too)
First troube is with HA as I shoul introduce 3 digit value for setting temp setpoint I guess this is an HA issue, but if some one knows how to solve it awould be great.
Anyway the main question of this topic is that if I want to set a lower value as 128 ( for 12.8°) I get a fault and the callbacp procedure void setterTemp(BYTE mode, WORD temp) is not called.
WHitin value from 128 and higher it works fine.
If I set a value highe than the highe limit. It works and give back the maxi value I've set in the declaration
ZUNO_THERMOSTAT(THERMOSTAT_FLAGS_OFF | THERMOSTAT_FLAGS_HEAT,
THERMOSTAT_UNITS_CELSIUS,
THERMOSTAT_RANGE_POS, 3,
getterMode, setterMode, getterTemp, setterTemp)
in my configuration 30°
Is it a bug that lower value thant 128 are not accepted? any work around? (I've tested on Jeedom and get same issues
Kind regards
Firmware ZUNO 3.0.10 (but tried with 3.0.12 beta too)
First troube is with HA as I shoul introduce 3 digit value for setting temp setpoint I guess this is an HA issue, but if some one knows how to solve it awould be great.
Anyway the main question of this topic is that if I want to set a lower value as 128 ( for 12.8°) I get a fault and the callbacp procedure void setterTemp(BYTE mode, WORD temp) is not called.
WHitin value from 128 and higher it works fine.
If I set a value highe than the highe limit. It works and give back the maxi value I've set in the declaration
ZUNO_THERMOSTAT(THERMOSTAT_FLAGS_OFF | THERMOSTAT_FLAGS_HEAT,
THERMOSTAT_UNITS_CELSIUS,
THERMOSTAT_RANGE_POS, 3,
getterMode, setterMode, getterTemp, setterTemp)
in my configuration 30°
Is it a bug that lower value thant 128 are not accepted? any work around? (I've tested on Jeedom and get same issues
Kind regards