Hi,
the Popp 123559 or POP_004308 Smoke Detector hast a temperature and humidity sensor.
However, during interview only the temperature sensor shows up:
http://a.b.c.d:8083/ZWaveAPI/Run/device ... .val.value
The "Device Configuration" page in the expert UI has configuration settings for humidity. But
how can I get the humidity value?
No Humidity from Popp 123559 or POP_004308 Smoke Detector
Re: No Humidity from Popp 123559 or POP_004308 Smoke Detecto
Got the answer from Popp:
The current hardware version has problems with the humidity sensor calibration.
Therefore the humidity sensor is currently disabled and will be replaced by other
hardware in a few months...
The current hardware version has problems with the humidity sensor calibration.
Therefore the humidity sensor is currently disabled and will be replaced by other
hardware in a few months...