Can't update Firmware

[pepeEL]

But FW 5.16 RaZberry GPIO probably not working with Domoticz. This info send me some user. Is new release from february will work with Domoticz ?

[PoltoS]

It was not working at all. Because you forgot to upgrade bootloader first. It will if you don't forget

[pepeEL]

No no. User who send me this info upgrade bootloader and upgrade FW. And for henot working with domotcz but workingwith zwave.me

[pepeEL]

Please explaine me more cleary because i dont understand... and tgen i try prepare file for this users to write to epprom.

This file has 0x1800 zeroes before the f/w. So to make the correct file one need to:
1. Remove first 0x1800 bytes
2. Prepend one byte 0x01
3. Prepend 0x77ff bytes with 0x00

Means the file is:
00 00 00 00 .... 6144 bytes with zeros in total 00 00 XX XX XX ... more data ... XX XX XX
And should become:
00 00 00 00 .... 30719 bytes with zeros in total 00 00 01 XX XX XX ... more data ... XX XX XX

Is any plan to release new stable firmware for Razberry Me GPIO ?

It is even not yet released by Sigma But if you upgrade bootloader and then the f/w, it will work. Better to wait for a release (around Feb)

Tell me also...range on new RaZberry 2 is very better than on my RaZberry 1 ?

IMHO, yes! About twice better

I dont understand how prepare file for USB Razberry.
I must remove all data and replace it with 00 to address 0x1800 ?

Then i dont understand what you mean in point 2. Prepend one byte 0x01 ?

3. And replace data in this one address 0x77ff to data 00 ?

[PoltoS]

Forget, I'll do myself upon request.

[pepeEL]

Forget, I'll do myself upon request.

I dont understand ?

[PoltoS]

If you don't need it, forget about it. I think you don;t need it, right?

[pepeEL]

Ok

[sboui]

Hi Geeks,
I looked for the .bin file (UPD_FIRMWARE_Razberry_from_05_10_to_05_04_.bin ).
I wonder if you can help me.
Thankss a lot.

[pepeEL]

Hi
You need file bin for external programmer ?