Hello,
i want to create a rule that control the volume from the sonos device.
For expample:
When volume is greater then 60 then set volume to 60.
With the sonos app it is possible to set the volume but i can't find the feature to read the actual volume setting.
Is it possible to add this feature to the sonos app?
Thanks.
Sonos App missing feature...
Sonos App missing feature...
Raspberry PI with Z-Wave.me Board
2 x Fibaro Double Relay-Switch FGS 222
2 x Fibaro Shutter FGR 222
Fibaro Multi Sensor
Z-Wave.me RemoteControl
2 x Fibaro Double Relay-Switch FGS 222
2 x Fibaro Shutter FGR 222
Fibaro Multi Sensor
Z-Wave.me RemoteControl
Re: Sonos App missing feature...
The device (dimmer) that corresponds to the volume should update its state when volume level is changed. You can use it in rules