- Posts: 15
- Joined: 27 Mar 2017 00:09
Is there a way to communicate between a atmega328 and the Z-UNO? The TX&RX pin on the mega is already in use. maybe possible to use I2c?
- Posts: 5705
- Joined: 26 Jan 2011 19:36
You can use SPI, I2C or even own digital protocol on a pin (or on many pins). This is up to your imagination
- Posts: 181
- Joined: 04 Aug 2016 07:14
You could use SoftwareSerial on mega328 too, but I prefer I2C, because you could use only 2 pins for a number of devices. In that case you have to configure mega328 as I2C slave device.