I have a UZB stick with version 5.19 runs on RPI, I was thinking to manually update it, but the instructions here https://z-wave.me/zmeserialupdater-manual/ aren't clear enough for me.
what is the correct procedure, and should I even risk it? can I brick it?
Is there significant improvements between the versions?
This is my stick info:
Code: Select all
SERIAL INFO
VERSION: 05 19 VENDOR: 01 15
ZME_CAPABILITIES
VENDOR: 00 00 NODES: FF
FLAGS: 05 00 00 00 00 00 00 00 00 00 00 00 00
FIRMWARE CRC
BOOT: BB BB FW: 42 71
MISC
FREQ: EU
Eli