wondering if its possible to reprogram/revive a bricked uzb stick by uart connection and if possible to know what pinout needed for it?
Also if its possible to reprogram the chip by z wave programmer by silabs:
https://www.silabs.com/community/wirele ... overi-5sGv
my update came as far as this, afterwards the stick wouldnt work:
Code: Select all
[2020-11-21 16:23:51.123] [D] [zway] Opened device: \\.\COM4
[2020-11-21 16:23:51.123] [W] [i/o] Failed to alter device settings: 31
[2020-11-21 16:23:51.123] [D] [zway] Worker thread successfully created
[2020-11-21 16:23:51.123] [D] [zway] Worker thread entry point
[2020-11-21 16:23:51.139] [I] [zway] Adding job: Get controller info and supported function classes
[2020-11-21 16:23:51.150] [D] [zway] SENDING: ( 01 03 00 07 FB )
[2020-11-21 16:29:32.417] [C] [i/o] Serial port write error: The I / O operation has been terminated due to a thread termination or a request from an application.