I am close to finish my current project, even with some 'unstable' workarounds (see my previous topics)...
In fact, I am porting a Z-Uno1 application to Z-uno2 board taking advantage of increases in performances to add some functionnalities.
My last problem is that, when performing calibration of ADC channels, I found a large difference in the final coefficient [ mV = Coef * binvalue]: 26.0 instead of 17.0
When I apply 2.3V on ADC (1 or/and 2), I get 468 binary levels (ie around 5mV/level).
So that full range (1024b) corresponds to 5V instead of 3V on Z-Uno1.
Is this what was expected?
Regards,
Yves
Here is my config (Only the first point is relevant for that issue):
- Z-Uno bootloader version:3.0.9
Security:none
Frequency:EU
Device included:yes
Device included securely by controller:no
Controller:Fibaro HC2